Suction Strainer Introduction
 
  • All products feature pleated mesh media and large filtration areas resulting in durable, long-life products.
  • Brass mesh media suction strainers can be cleaned and re-used over and over again.
  • Can be cleaned with compressed air or by simply immersing into cleaning fluid.
 
[SFA Type]

 
[SFB Type]









Outside Appearance
(color difference between 
brass and stainless steel)

  • This design is particularly suited to easy maintenance, the non-screw type coupling and guide rod make installation or removal easy whether or not the tank is filled with oil.
  • The length of the center rod can be adjusted in millimeter increments via the center bolt, allowing easy adjustments to fit a variety of sizes of oil and hydraulic tanks.
  • Large size strainer provides high flow rate capacity for large hydraulic circuits
  • Port size: 1.5" to 5 inch
  • The photo to the left shows the outward difference in appearance between the traditional brass mesh media and the new stainless steel mesh. Since the mesh material is the only difference, compatibility and interchangeability is assured.
    (Left: stainless steel mesh strainer; Right: traditional brass mesh strainer)
  • Simple transformation into a magnetic strainer with the addition of magnetic bars spaced around our existing strainer design
 
[SFC Type]

  • This built-in flange design strainer can be installed from the outside of the oil tank directly onto the suction port and offers cost savings over other types of suction strainers by eliminating the need for a dedicated in-tank flange
  • Even if this strainer is installed at the bottom of the oil tank, its unique design allows for effective filtration regardless of sedimentation.
  • Ideal for low flow capacity oil circuits.
  • Port size: R1/2" to R1.25 inch

Suction Strainer Introduction